CN Heavy Transport Deploys New SCHEUERLE STB 260 in Norway

Norwegian heavy haulage specialist CN Heavy Transport has put its new SCHEUERLE STB 260 side girder bridge into service on two transformer moves between the Port of Bogen and Bjørnfjell near the Swedish border. The transformers weighed 128 and 185…

Lena Johnson1 min read
CN Heavy Transport Deploys New SCHEUERLE STB 260 in Norway
Rate this post

Norwegian heavy haulage specialist CN Heavy Transport has put its new SCHEUERLE STB 260 side girder bridge into service on two transformer moves between the Port of Bogen and Bjørnfjell near the Swedish border.

The transformers weighed 128 and 185 tonnes respectively and were transported over a route of around 70 kilometres through northern Norway.

TII SCHEUERLE STB260 CN Heavy Transformer 185 tons North Norway to Swedish border October 2026 Markus Voelter 235

The heavier unit measured approximately 9 metres long, 3.2 metres wide and 4.65 metres high. Together with the side girder bridge, modular trailers and prime movers, the complete transport combination reached a gross vehicle weight of 386 tonnes and an overall length of 71.5 metres.

The route climbed from sea level to around 500 metres and included sections of the E10 and E6, gradients of up to 10%, tight roundabouts and multiple tunnels.

TII SCHEUERLE STB260 CN Heavy Transformer 185 tons North Norway to Swedish border October 2026 Markus Voelter 191

One of the most demanding sections was the Leirvik Tunnel, where the transport had just 5 cm of clearance to the roof at its tightest point.

“Particularly impressive was the journey from sea level to an altitude of around 500 metres, including gradients of up to ten percent, the negotiation of traffic islands and extremely tight tunnel clearances,” said Ole Kristian Ruud, Project Manager at CN Heavy Transport AS.

For the two moves, the STB 260 was combined with 2 × 12 axle lines of NICOLAS modular platform trailers.

TII Scheuerle

The side girder bridge has a deadweight of around 40 tonnes and a rated payload of up to 260 tonnes. It also offers a lifting range of 1,500 mm, multiple girder configurations and an integrated roll stabilisation system.

The STB 260 can be combined with both SCHEUERLE K25 and existing NICOLAS modular trailer fleets.

The transformers were manufactured by Tamini in Italy and transported to Norway by road and sea before CN Heavy handled the final leg to Bjørnfjell.

Rate this article
Rate this post
Found it useful? Share it with your network
Get stories like this every weekdayFree newsletter, read by 120,000 industry professionals.
Subscribe free

AdvertisementAdvertise here

Regal RexnordTII SCHEUERLE

Read more in MOVE IT Magazine

Features, interviews and reports on the biggest lifts and moves. Free for registered readers.